Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: CARMELO CONSTRUCTION, INC.

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of CARMELO CONSTRUCTION, INC. in 1 MONTELLA CIRCLE, LIMERICK, PA 19468 (NAICS 238350). OSHA activity number 342266558.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Carmelo Construction, INC. — free Get an email when a new federal OSHA severe-injury report for Carmelo Construction, INC. is published. One employer, no account, unsubscribe in one click.
Site address
1 MONTELLA CIRCLE
City
LIMERICK
State
PA
ZIP
19468
Mailing
3323 HARTVILLE STREET, PHILADELPHIA, PA 19134
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238350
Employees
4
Ownership type
A

7 citations on file for this inspection.

1926.25 A

Serious Gravity 1 1 instance 4 exposed
Issued
May 8, 2017
Penalty
Initial $1,847 · Current $1,847
29 CFR 1926.25(a): During the course of construction, alteration, or repairs, form or scrap lumber with protruding nails was not kept clear from work areas:  a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, employees are installing siding and other related materials on a residential home project where scrap lumber with protruding nails was not kept clear from the work areas.
Recent events (1)
  • — Z (S) $1847

1926.451 B05 II

Serious Gravity 5 1 instance 1 exposed
Issued
May 8, 2017
Abate by
May 18, 2017
Penalty
Initial $2,897 · Current $2,897
29 CFR 1926.451(b)(5)(ii): The end of a platform greater than 10 feet in length extended over its support more than 18 inches and the platform was not designed and installed so that the cantilevered portion of the platform is able to support employees without tipping, or has guardrails which block employee access to the cantilivered end:  a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, an employee was working from a pump jack scaffold where an extension of the working platform of approximately four feet was placed on one end, which extended the platform length approximately seven feet beyond its nearest support.
Recent events (1)
  • — Z (S) $2897

1926.451 C02

Serious Gravity 5 1 instance 3 exposed
Issued
May 8, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.451(c)(2): Supported scaffold poles, legs, posts, frames,  or uprights did not bear on base plates, mud sills or other adequate firm foundation:  a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, an employee was working from a pump jack scaffold, which did not have each of its pole ends bearing on mudsills.
Recent events (1)
  • — Z (S) $0

1926.452 J02

Serious Gravity 5 1 instance 3 exposed
Issued
May 8, 2017
Abate by
May 18, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.452(j)(2): Poles were not secured to the structure by rigid triangular bracing or equivalent at the bottom, top, and other points as necessary.  a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, employees were working from pump jack scaffolds where each pole was secured to the structure by only a single triangular brace.
Recent events (1)
  • — Z (S) $0

1926.1053 B05 I

Serious Gravity 1 1 instance 1 exposed
Issued
May 8, 2017
Penalty
Initial $1,847 · Current $1,847
29 CFR 1926.1053(b)(5)(i): Non-self-supporting ladder(s) were not used at an angle such that the horizontal distance from the top support to the foot of the ladder was approximately one-quarter of the working length of the ladder:   a)  1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, an employee is performing siding installation while using an extension ladder to access an adjacent pump jack scaffold, but the ladder is set where the angle is in excess of one-quarter of the working length of the ladder.
Recent events (1)
  • — Z (S) $1847

1926.451 G01

Repeat Gravity 5 1 instance 1 exposed
Issued
May 8, 2017
Penalty
Initial $7,243 · Current $7,243
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:  a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, an employee was working from a pump jack scaffold, approximately 17 feet above a lower level, without being protected from falling to that lower level.   Carmelo Construction, Inc.  was previously cited for a violation of a similar occupational safety and health standard, 29 CFR 1926.451(g)(4)(i) which was contained in OSHA inspection number 1178420, citation number 1, item number 2a and was affirmed as a final order on February 21, 2017, with respect to a workplace located at 1819 Ginnoda Street, Philadelphia, PA 19130.
Recent events (1)
  • — Z (R) $7243

1926.501 B13

Repeat Gravity 5 1 instance 1 exposed
Issued
May 8, 2017
Penalty
Initial $7,243 · Current $7,243
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501(b):   a) 1 Montella Circle, Limerick, PA, Worksite - on or about April 12, 2017, employees were installing siding to a residential home project while working on steeply pitched roof, approximately 17 feet above grade, without utilizing any means of fall protection.   Carmelo Construction, Inc.  was previously cited for a violation of this occupational safety and health standard, 29 CFR 1926.501(b)(13) which was contained in OSHA inspection number 1191483, citation number 1, item number 1 and was affirmed as a final order on January 18, 2017, with respect to a workplace located at Lot 47, David Drive, Newtown, PA 18940.
Recent events (1)
  • — Z (R) $7243

View Carmelo Construction, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342266558.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.