CLIFTON, NJ —
OSHA Inspection: WSZ FRAMING INC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of WSZ FRAMING INC in 111 VIRGINIA AVE, CLIFTON, NJ 07012 (NAICS 238130). OSHA activity number 342728748.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- WSZ FRAMING INC
- Site address
- 111 VIRGINIA AVE
- City
- CLIFTON
- State
- NJ
- ZIP
- 07012
- Mailing
- 147 BRICHWOOD DR, ELMWOOD PARK, NJ 07407
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 5
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.102 A01
- Issued
- Apr 17, 2018
- Penalty
- Initial $2,217 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.102(a)(1): The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. a) Exterior of Building - Roof Front : Employees were exposed to eye injury while engaged in framing activities without the use of eye or face protection, on or about 10/25/17.
Recent events (2)
- — I (S) $1200
- — Z (S) $2217
1926.403 B02
- Issued
- Apr 17, 2018
- Penalty
- Initial $2,217 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.403(b)(2): Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification: a) Interior: Employees engaged in framing work were exposed to electric shock while connecting electric tools to loose metal boxes fed by electric cables, on or about 10/31/17.
Recent events (2)
- — I (S) $1200
- — Z (S) $2217
1926.404 B01 I
- Issued
- Apr 17, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.404(b)(1)(i): General. The employer shall use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites. These requirements are in addition to any other requirements for equipment grounding conductors. a) Interior of Building: Employees were exposed to electric shock while using electric appliances including but not limited to a electric circular saw and battery charger that were not protected by a GFCI or an assured equipment grounding conductor program; on or about 10/25/17.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.501 B13
- Issued
- Apr 17, 2018
- Penalty
- Initial $3,880 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): a) Exterior of Building - Roof Front: Employees without proper means of fall protection were exposed to fall hazards of approximately 20 feet while engaged in framing activities , on or about 10/25/17.
Recent events (2)
- — I (S) $1200
- — Z (S) $3880
1926.602 D
- Issued
- Apr 17, 2018
- Abate by
- May 7, 2018
- Penalty
- Initial $2,217 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.602(d): The employer did not certify that each operator had been trained and evaluated as required by paragraph 29 CFR 1910.178(l):Note: The requirements applicable to construction work under paragraph (d) of this section are identical to those set forth at paragraph (l) of 29 CFR 1910.178. a) Exterior of Building - Back of House: The employer did not ensure that the operators of the all terrain forklift were certified, on or about 10/25/17.
Recent events (2)
- — I (S) $1200
- — Z (S) $2217
1926.1053 B13
- Issued
- Apr 17, 2018
- Penalty
- Initial $2,217 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.1053(b)(13): The top or top step of a stepladder shall not be used as a step. a) Interior of Building - Second Floor - Front: Employees engaged in framing activities were exposed to fall hazards of approximately 4 feet while using the top step of a step ladder, on or about 10/25/17.
Recent events (2)
- — I (S) $1200
- — Z (S) $2217
More inspections at WSZ Framing INC
View WSZ Framing INC's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342728748.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.