GLENVILLE, NY —
OSHA Inspection: ICF PANELS, LLC
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of ICF PANELS, LLC in 202A GLENVILLE INDUSTRIAL PARK, GLENVILLE, NY 12302 (NAICS 493110). OSHA activity number 343693651.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ICF PANELS, LLC
- Site address
- 202A GLENVILLE INDUSTRIAL PARK
- City
- GLENVILLE
- State
- NY
- ZIP
- 12302
- Mailing
- 202A GLENVILLE INDUSTRIAL PARK, GLENVILLE, NY 12302
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 493110
- Employees
- 14
- Ownership type
- A
Citations
6 citations on file for this inspection.
5(a)(1)
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $3,789 · Current $2,273 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that an employee was exposed to struck-by hazards due to using a below-the-hook lifting device without the proper markings, construction, and installation: a) Warehouse - On or prior to December 4, 2018, employees were exposed to struck-by hazards when working around a below-the-hook lifting device (spreader bar made in-house) that was not tested or load rated. The below-the-hook lifting device is used to lift approximately 600-1500 lb walls and did not have any markings.
Recent events (3)
- — F (S) $2273.4
- — C (S) $3789
- — Z (S) $3789
1910.28 B01 I
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $3,789 · Current $2,273 Reduced
General-duty citation text
29 CFR 1910.28(b)(1)(i): The employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that was 4 feet (1.2 m) or more above a lower level was protected from falling by one or more of the following: a) Warehouse - On or about December 4, 2018, employees were exposed to fall hazards of approximately 12 feet due to working on top of the walls bracing the walls together without fall protection.
Recent events (3)
- — F (S) $2273.4
- — C (S) $3789
- — Z (S) $3789
1910.30 A01
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.30(a)(1): The employer did not provide training to each employee who uses personal fall protection systems or who is required to be trained as specified elsewhere in this subpart prior to being exposed to a fall hazard: a) Warehouse - On or prior to January 4, 2019, employees were not provided training in fall protection.
Recent events (3)
- — F (S) $0
- — C (S) $0
- — Z (S) $0
1910.135 A01
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $2,273 · Current $1,364 Reduced
General-duty citation text
29 CFR 1910.135(a)(1): The employer did not ensure that each affected employee wear a protective helmet when working in areas where there is a potential for injury to the head from falling objects: a) Warehouse - On or prior to January 4, 2019, employees were not provided hard hats when working around and lifting walls with a crane.
Recent events (3)
- — F (S) $1363.8
- — C (S) $2273
- — Z (S) $2273
1910.303 B02
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling: a) Warehouse - On or about January 4, 2019, a relocatable power tap (RPT) or power strip powering various electrical equipment was not installed and used in accordance with instruction in the listing, labeling, or certification such as, but not limited to, being permanently secured to a wall and used as a substitute for fixed wiring.
Recent events (3)
- — F (O) $0
- — C (O) $0
- — Z (O) $0
1910.305 G01 IV A
- Issued
- Apr 9, 2019
- Abate by
- Dec 16, 2019
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure: a) Warehouse - On or about January 4, 2019, extension cords were plugged into various outlets, extensions, and a relocatable power tap (RPT) being used as permanent wiring powering various equipment.
Recent events (3)
- — F (O) $0
- — C (O) $0
- — Z (O) $0
More inspections at ICF Panels, LLC
View ICF Panels, LLC's full OSHA safety record →
More inspections in this industry (NAICS 493110)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343693651.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.