Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: PRECIOUS PLATE, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of PRECIOUS PLATE, INC. in 2124 LIBERTY DRIVE, NIAGARA FALLS, NY 14304 (NAICS 332813). OSHA activity number 344083910.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Precious Plate, INC. — free Get an email when a new federal OSHA severe-injury report for Precious Plate, INC. is published. One employer, no account, unsubscribe in one click.
Site address
2124 LIBERTY DRIVE
City
NIAGARA FALLS
State
NY
ZIP
14304
Mailing
2124 LIBERTY DRIVE, NIAGARA FALLS, NY 14304
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332813
Employees
145
Ownership type
A

5 citations on file for this inspection.

1910.28 B01 I

Serious Gravity 5 1 instance 4 exposed
Issued
Sep 5, 2019
Abate by
Oct 7, 2019
Penalty
Initial $6,819 · Current $3,000 Reduced
29 CFR 1910.28(b)(1)(i): The employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that was 4 feet (1.2 m) or more above a lower level was protected from falling by one or more of the following:  Guardrail systems, safety net systems, or personal fall arrest systems:    a) On or about 06/17/19 at the upper mezzanine above Lines 10-13; employees were exposed to a fall hazard of eleven feet when the top rail and mid rail of the guardrail system on the northwest corner of this area consisted of chains between the post frames.      ABATEMENT CERTIFICATION REQUIRED
Recent events (3)
  • — J (S) $3000
  • — C (S) $6819
  • — Z (S) $6819

1910.28 B03 IV

Serious Gravity 5 2 instances 6 exposed
Issued
Sep 5, 2019
Abate by
Oct 7, 2019
Penalty
Initial $0 · Current $0
29 CFR 1910.28(b)(3)(iv): Each employee was not protected from falling into the ladderway platform hole at the entrance to the hole by a self-closing gate or offset.  a) On or about 06/17/19 in the Waste Water Treatment area; employees were exposed to a fall hazard of seven feet when the ladderway platform entrance opening on the Scrubber Liquid platform was protected with two chains.   b) On or about 06/17/19 in the Waste Water Treatment area; employees were exposed to a fall hazard of 53 inches when the ladderway platform entrance on the H filter press platform was protected with two chains.    ABATEMENT CERTIFICATION REQUIRED
Recent events (3)
  • — J (S) $0
  • — C (S) $0
  • — Z (S) $0

1910.147 C06 I

Serious Gravity 1 1 instance 4 exposed
Issued
Sep 5, 2019
Abate by
Oct 7, 2019
Penalty
Initial $5,115 · Current $2,000 Reduced
29 CFR 1910.147(c)(6)(i): The employer did not conduct an annual or more frequent inspection of the energy control procedure to ensure that the procedure and requirements of this standard were followed:    a) On or about 06/13/19 throughout the facility; employees were exposed to contact with electrical current when the employer's last certified periodic inspection of the Rittel Cabinet Lockout / Tagout Procedure was conducted on 01/14/18.      ABATEMENT CERTIFICATION REQUIRED
Recent events (3)
  • — J (S) $2000
  • — C (S) $5115
  • — Z (S) $5115

1910.335 A01 I

Serious Gravity 5 2 instances 4 exposed
Issued
Sep 5, 2019
Abate by
May 28, 2020
Penalty
Initial $6,819 · Current $3,000 Reduced
29 CFR 1910.335(a)(1)(i): Employees working in areas where there were potential electrical hazards were not provided with electrical protective equipment that was appropriate for the specific parts of the body that needed to be protected and for the work being performed:    a) On or about 08/13/19 throughout the production areas; employees were exposed to flash burns to face and eyes while conducting voltage testing on the Rittel cabinets ( 480 volts AC), such as but not limited to, Rittel cabinet #27, when employer required only safety glasses for eye and face protection.      b) On or about 08/13/19 throughout the production areas; employees were exposed to flash burns to hands while conducting voltage testing on the Rittel cabinets ( 480 volts AC), such as but not limited to, Rittel cabinet #27, when employer did not require hand protection.        ABATEMENT CERTIFICATION REQUIRED
Recent events (3)
  • — J (S) $3000
  • — C (S) $6819
  • — Z (S) $6819

1910.157 G04

Other-than-serious 1 instance 100 exposed
Issued
Sep 5, 2019
Penalty
Initial $0 · Current $0
29 CFR 1910.157(g)(4): Employees who have been designated to use fire fighting equipment as a part of the emergency action plan were not provided training in the use of appropriate equipment upon initial assignment and at least annually thereafter:  a) On or about 06/17/19 throughout the facility; employees who were designated by employer to use fire fighting equipment, were last trained on the use of a fire extinguisher on or before 06/17/18.    NO ABATEMENT CERTIFICATION REQUIRED
Recent events (3)
  • — J (O) $0
  • — C (O) $0
  • — Z (O) $0

View Precious Plate, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344083910.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.