BRISTOL, SD —
OSHA Inspection: BROTHERS CONSTRUCTION LLC
Federal Agency inspection · Safety discipline
At a glance
On , OSHA opened a federal Agency safety inspection of BROTHERS CONSTRUCTION LLC in 14648 423RD AVENUE, BRISTOL, SD 57219 (NAICS 238130). OSHA activity number 344942222.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- BROTHERS CONSTRUCTION LLC
- Site address
- 14648 423RD AVENUE
- City
- BRISTOL
- State
- SD
- ZIP
- 57219
- Mailing
- 511 COTTONWOOD DRIVE, HARRISBURG, SD 57032
What kind of inspection was it?
- Inspection type
- Federal Agency (M)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 7
- Ownership type
- A
Citations
6 citations on file for this inspection.
1910.178 L01 I
- Issued
- Jan 27, 2021
- Abate by
- Mar 23, 2021
- Penalty
- Initial $3,511 · Current $2,000 Reduced
General-duty citation text
29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator was competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l): (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure a forklift operator was trained in the operation of powered industrial trucks in that, prior to using rough terrain forklifts. Two rough terrain forklifts were used to lift corrugated steel decking material and a personnel basket to perform roofing activities. This condition exposed the employee to the hazard of improper forklift operation. Abatement Note: Training shall consist of a combination of formal instruction (e.g., lecture, discussion, interactive computer learning, video tape, written material), practical training (demonstrations performed by the trainer and practical exercises performed by the trainee), and evaluation of the operator's performance in the workplace. Abatement Note: The requirements applicable to construction work under 1926.602(d) are identical to those set forth at �1910.178(l) of this chapter. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $2000
- — Z (S) $3511
1926.451 C02 IV
- Issued
- Jan 27, 2021
- Abate by
- Feb 23, 2021
- Penalty
- Initial $2,341 · Current $0 Reduced
General-duty citation text
29 CFR 1926.451(c)(2)(iv): Front-end loaders and similar pieces of equipment were used to support scaffold platforms without being specifically designed by the manufacturer for such use: (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure employees were protected from serious injury by the use of an elevated work platform which was designed, constructed, and used in accordance with the requirements of the forklift manufacturer. The employer utilized the forklift platform to line up and secure 42-foot by 3-foot roof panels. The platform was not specifically designed to meet the ASME B56.6a-1994 requirements regarding the use of personnel on the platform. The platform was not equipped with adequate guardrails or a data plate identifying overall weight. This condition exposed an employee to a fall hazard of approximately 16 feet. Abatement Note: Preamble to Subpart L promulgated new paragraph (c)(2)(iv) & (v) in final rule to provide guidance. Added provision requires that in the case of fork-lifts, the entire scaffold platform be secured to the forklift. Abatement Note: Among other methods, one feasible and acceptable abatement method to correct this hazard is to ensure that all platforms used for elevating personnel with a rough terrain forklift truck comply with the design requirements specified in ASME B56.6a-1994, American Society of Mechanical Engineers, "Safety Standards for Rough Terrain Forklift Trucks", Section 8.25, Platforms for Elevating Personnel, in the following areas: (1)Paragraph (b) which states, "floor dimensions which shall not exceed two times the load center distance listed on the rough terrain forklift truck nameplate, measured parallel to the longitudinal center plane of the truck, nor have a length greater than the overall width of the truck measured across the load bearing tires plus 10 in. (250 mm) on either side. (2)Paragraph (f) which states, "information prominently indicated on the platform: (1) maximum work load including personnel and equipment; (2) weight of empty platform." The ASME B56.6-1994 Section 8.2.5 standard can be obtained by contacting the American Society of Mechanical Engineers, 345 East 4th Street, New York, NY 10017. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $0
- — Z (S) $2341
1926.502 A02
- Issued
- Jan 27, 2021
- Abate by
- Mar 23, 2021
- Penalty
- Initial $3,511 · Current $2,200 Reduced
General-duty citation text
29 CFR 1926.502(a)(2): Employers did not provide and install all fall protection systems required by this subpart for an employee, and did not comply with all other pertinent requirements of this subpart before that employee began the work that necessitated the fall protection: (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure employees were protected from fall hazards while using Guardian vertical lifelines while installing corrugated steel roof panels on a wooden pole-to-truss cattle barn under construction. Employees were taking the snap-hook of vertical lifelines and looping it around the top chord of the truss and connecting it back onto the lifeline rope. The vertical lifeline was not designed this anchorage application. This condition exposed an employee to a fall hazard of approximately 16 feet. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $2200
- — Z (S) $3511
1926.502 D21
- Issued
- Jan 27, 2021
- Abate by
- Mar 23, 2021
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(d)(21): Personal fall arrest systems were not inspected prior to each use for wear, damage and other deterioration, and defective components were not removed from service: (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure that each personal fall arrest system was inspected prior to use, and that defective components were removed from service. Employees were using a Guardian 50-foot Poly Steel Rope Vertical Lifeline assembly part #01320, as a part of the personal fall arrest systems used during the installation of steel corrugated roofing panels on a post-and-truss cattle barn. This condition exposed employees to a fall hazard of approximately 16 feet. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.760 A01
- Issued
- Jan 27, 2021
- Abate by
- Mar 23, 2021
- Penalty
- Initial $3,511 · Current $3,000 Reduced
General-duty citation text
29 CFR 1926.760(a)(1): Each employee engaged in steel erection activity who is on a walking/ working surface with an unprotected side or edge more than 15 feet above a lower level was not protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems or fall restraint systems. (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure an employee was protected from fall hazards while installing 42-foot long by 3-foot wide corrugated steel roof decking material on the roof of a wooden pole-to-truss cattle barn under construction. Employees were utilizing a Guardian 50-foot Poly Steel Rope Vertical Lifeline assembly as a fall protection system while working on the roof. Employees were disconnecting the lifeline snap-hook from the anchor which consisted of the wooden trusses and walking to the next area where roof panels were being installed without the protection of a fall protection system. This condition exposed an employee to a fall hazard of approximately 16 feet. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $3000
- — Z (S) $3511
1926.503 B01
- Issued
- Jan 27, 2021
- Abate by
- Mar 23, 2021
- Penalty
- Initial $3,511 · Current $2,500 Reduced
General-duty citation text
29 CFR 1926.503(b)(1):The employer did not verify compliance with paragraph (a) of this section by preparing a written certification record: (a)Brothers Construction, LLC @ 14648 423rd Avenue, Bristol, SD 57219: On or about and at times prior to September 1, 2020, the exposing employer did not ensure a written fall protection training certification record was prepared which included the identifies of employees trained, dates of training, and the signatures of the trainer or employer. Employees were working on the roof of a post-to-truss cattle barn installing steel corrugated roof panels while improperly using vertical lifelines looped around trusses with the snap-hook connected directly to the rope. This condition exposed an employee to a fall hazard of approximately 16 feet. Abatement Note: The written certification record shall contain the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer. If the employer relies on training conducted by another employer or completed prior to the effective date of this section, the certification record shall indicate the date the employer determined the prior training was adequate rather than the date of actual training. Brothers Construction, LLC was previously cited for a violation of this occupational safety and health standard or its equivalent standard CFR 1926.503(b)(1), which was contained in OSHA inspection number 1395838, citation number 1, item number 1c, and was affirmed as a final order on July 24, 2019, with respect to a workplace located at 1201 South Hyde Park Avenue, Sioux Falls, SD 57106. Abatement Note: Abatement documentation and certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $2500
- — Z (R) $3511
More inspections at Brothers Construction LLC
View Brothers Construction LLC's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in SD
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344942222.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.