RAMSEY, NJ —
OSHA Inspection: LEEM/LSS FILTRATION
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of LEEM/LSS FILTRATION in 25 ARROW ROAD, RAMSEY, NJ 07446 (NAICS 333318). OSHA activity number 347129215.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LEEM/LSS FILTRATION
- Site address
- 25 ARROW ROAD
- City
- RAMSEY
- State
- NJ
- ZIP
- 07446
- Mailing
- 25 ARROW ROAD, RAMSEY, NJ 07446
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 333318
- Employees
- 21
- Ownership type
- A
Citations
4 citations on file for this inspection.
1910.110 E04 III
- Issued
- May 20, 2024
- Penalty
- Initial $2,765 · Current $0 Reduced
General-duty citation text
29 CFR 1910.110(e)(4)(iii): LP gas container(s) installed on internal combustion engine vehicles were not securely mounted to prevent jarring loose, slipping or rotating: a) Shop: LP Gas container was improperly installed on a Toyota forklift. The LPG thank was not properly securely mounted to prevent jarring loose and slipping or rotating. The index pin was missing preventing the tank from rotating, on or about 11/27/23.
Recent events (2)
- — I (O) $0
- — Z (S) $2765
1910.133 A01
- Issued
- May 20, 2024
- Penalty
- Initial $2,765 · Current $0 Reduced
General-duty citation text
29 CFR 1910.133(a)(1): Eye and face protection. General requirements. The employer did not ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. a) An employee was exposed to eye and face injury while using prescription glasses without side shield and did not meet safety glasses requirements, on or about 11/27/24.
Recent events (2)
- — I (S) $0
- — Z (S) $2765
1910.213 H01
- Issued
- May 20, 2024
- Penalty
- Initial $5,531 · Current $2,750 Reduced
General-duty citation text
29 CFR 1910.213(h)(1): The sides of the lower exposed portion of the blade of radial saw(s) were not guarded to the full diameter of the blade by a device that automatically adjusted itself to the thickness of the stock and remained in contact with the stock being cut to give maximum protection possible for the operation being performed: a) Delta radial saw: The blade guard was damage, exposing the lower portion of the blade of the radial saw. Employees were expose to amputations while in use of the saw, on or about 11/27/23.
Recent events (2)
- — I (S) $2750
- — Z (S) $5531
1910.243 A02 II
- Issued
- May 20, 2024
- Penalty
- Initial $5,531 · Current $0 Reduced
General-duty citation text
29 CFR 1910.243(a)(2)(ii): All hand-held powered drills, tappers, fastener drivers, horizontal, vertical, and angle grinders with wheels greater than 2 inches in diameter, disc sanders with discs greater than 2 inches in diameter, belt sanders, reciprocating saws, saber, scroll, and jig saws with blade shanks greater than a nominal one-fourth inch, and other similarly operating powered tools shall be equipped with a constant pressure switch or control, and may have a lock-on control provided that turnoff can be accomplished by a single motion of the same finger or fingers that turn it on. a) Fabrication Department: The employer failed to ensure that handheld angle grinder was equipped with a safety guard, on or about 11/27/24.
Recent events (2)
- — I (S) $0
- — Z (S) $5531
More inspections at Leem/Lss Filtration
View Leem/Lss Filtration's full OSHA safety record →
More inspections in this industry (NAICS 333318)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347129215.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.