SCOTTSVILLE, NY —
OSHA Inspection: SABIN METAL CORPORATION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of SABIN METAL CORPORATION in 1647 WHEATLAND CENTER ROAD, SCOTTSVILLE, NY 14546 (NAICS 000000). OSHA activity number 305232340.
What this inspection record means
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Watch Sabin Metal Corporation — free
Get an email when a new federal OSHA severe-injury report for Sabin Metal Corporation is published. One employer, no account, unsubscribe in one click.
Where did this inspection happen?
- Establishment
- SABIN METAL CORPORATION
- Site address
- 1647 WHEATLAND CENTER ROAD
- City
- SCOTTSVILLE
- State
- NY
- ZIP
- 14546
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3341
- Employees
- 222
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
24 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $825 · Current $495 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling to the ground while working in an unsecured platform, lacking standard guardrails on all sides, and raised in the air by the forks of a powered industrial truck. a) On or about 6/18/02, in the north addition of the Main Plant: Employees were exposed to falls of approx. 4 ft. 3 in. while sealing furnace doors from a "homemade cage type workplatform" raised in the air by the forks of various forklift trucks. The workplatform was not secured to the truck. There was visible damage at the bottom, and the side closest to the furnace lacked guardrails. b) On or about 6/18/02, in the Main Plant: Employees were exposed to falls of approx. 4 ft. 3 in. while sealing "A" furnace doors from a "homemade cage type workplatform" raised in the air by the forks of various forklift trucks. The workplatform was not secured to the truck. There were no "pockets" for the forks at the bottom of the platform, and two sides lacked standard guardrails. Among others, a feasible method to eliminate or materially reduce this hazard is to: 1. Repair visible damage, & inspect workplatform for other damage. 2. Install properly sized chains or other means to fasten the workplatform to the forklift. 3. Have the cage & chains approved by a registered professional engineer. 4. install standard guardrails or the equivalent on all sides of the platform. 5. Redesign the cage so that the forks of the truck will be inserted into properly sized "slots" positioned at the bottom of the cage such that the platform is properly balanced when raising. ABATEMENT CERTIFICATION REQUIREDATION
Recent events (2)
- — I (S) $495.00
- — Z (S) $825.00
5(a)(1)
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,925 · Current $1,155 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of being struck by falling loads suspended in the air by electric hoists for which a program of periodic & frequent inspections, and preventive maintenance had not been established. a) On or about 5/21/02, in the HPO dept., # 2 Room: Budgit Electric hoists are used to raise and lower "tumblers" into and out of acid tanks. No program of periodic & frequent inspections, and preventive maintenance had been established for these hoists. b) On or about 6/06/02, in the Maintenance Shop where Cincinatti Shear is located: Budgit Electric hoist on "underhung" crane is used to lift sheets of steel plate to be cut on the shear. No program of periodic & frequent inspections, and preventive maintenance had been established for this hoist. c) On or about 6/11/02, in the Weld Shop: Budgit Electric hoist on "underhung" crane is used to lift ductwork onto the weld table. No program of periodic & frequent inspections, and preventive maintenance had been established for this hoist. Among others, a feasible method to eliminate or materially reduce this hazard is to: 1. Establish a program of periodic & frequent inspections, and preventive maintenance based on the manufacturer's recommendations for these hoists. ABATEMENT CERTIFICATION REQUIRED
Recent events (2)
- — I (S) $1155.00
- — Z (S) $1925.00
1910.23 C01
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $825 · Current $495 Reduced
Recent events (2)
- — I (S) $495.00
- — Z (S) $825.00
1910.151 C
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,100 · Current $660 Reduced
Recent events (2)
- — I (S) $660.00
- — Z (S) $1100.00
1910.157 G02
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $825 · Current $495 Reduced
Recent events (2)
- — I (S) $495.00
- — Z (S) $825.00
1910.184 E03 I
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,100 · Current $660 Reduced
Recent events (2)
- — I (S) $660.00
- — Z (S) $1100.00
1910.212 A01
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,375 · Current $825 Reduced
Recent events (2)
- — I (S) $825.00
- — Z (S) $1375.00
1910.213 B03
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,100 · Current $660 Reduced
Recent events (2)
- — I (S) $660.00
- — Z (S) $1100.00
1910.252 B02 III
- Issued
- Oct 22, 2002
- Abate by
- Jun 13, 2002
- Penalty
- Initial $701 · Current $420 Reduced
Recent events (2)
- — I (S) $420.00
- — Z (S) $701.00
1910.303 G02 I
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $3,500 · Current $2,100 Reduced
Recent events (2)
- — I (S) $2100.00
- — Z (S) $3500.00
1910.304 A02
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $825 · Current $495 Reduced
Recent events (2)
- — I (S) $495.00
- — Z (S) $825.00
1910.334 A02 II
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
1910.304 F04
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $825 · Current $495 Reduced
Recent events (2)
- — I (S) $495.00
- — Z (S) $825.00
1910.333 B02 IIIA
- Issued
- Oct 22, 2002
- Abate by
- Jun 26, 2002
- Penalty
- Initial $701 · Current $420 Reduced
Recent events (2)
- — I (S) $420.00
- — Z (S) $701.00
1910.335 A01 I
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
- Penalty
- Initial $1,100 · Current $660 Reduced
Recent events (2)
- — I (S) $660.00
- — Z (S) $1100.00
1910.335 A01 V
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
1910.106 D02 I
- Issued
- Oct 22, 2002
- Abate by
- Nov 8, 2002
1910.132 D02
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
1910.147 C05 II
- Issued
- Oct 22, 2002
- Abate by
- Nov 8, 2002
1910.157 C04
- Issued
- Oct 22, 2002
- Abate by
- Oct 25, 2002
1910.219 C02 I
- Issued
- Oct 22, 2002
- Abate by
- Nov 8, 2002
1910.303 B02
- Issued
- Oct 22, 2002
- Abate by
- Oct 25, 2002
1910.303 F
- Issued
- Oct 22, 2002
- Abate by
- Nov 25, 2002
1910.303 G01 I
- Issued
- Oct 22, 2002
- Abate by
- Oct 25, 2002
More inspections at Sabin Metal Corporation
Jun 6, 2018
SCOTTSVILLE, NY
Dec 16, 2015
SCOTTSVILLE, NY
Dec 10, 2013
SCOTTSVILLE, NY
Nov 1, 2007
EAST HAMPTON, NY
Jul 8, 2004
SCOTTSVILLE, NY
View Sabin Metal Corporation's full OSHA safety record →
More inspections in this industry (NAICS 000000)
Jan 5, 2012
Bruce D. Bowman · SCHENECTADY, NY
Jan 25, 2005
KGC, INC. · BILLINGS, MT
Dec 31, 2002
Rockaway Borough DPW · ROCKAWAY, NJ
Dec 31, 2002
Harry Brickey DBA a. Brickey Ceiling Company · FOREST CITY, NC
Dec 31, 2002
Sudden Bond Industries · EDGERTON, KS
More inspections in NY
Jul 17, 2026
Sullivan County Care Center at Sunset Lake · LIBERTY, NY
Jul 17, 2026
Vergara Electrical LLC · NEW YORK, NY
Jul 17, 2026
Apple Converting, INC. · ONEONTA, NY
Jul 17, 2026
Namicela Home Solutions INC · SYRACUSE, NY
Jul 17, 2026
Cranesville Block CO., INC. · SYRACUSE, NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 305232340.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.