DENVER, CO —
OSHA Inspection: TOP SHOP INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of TOP SHOP INC. in 3220 E. 52ND AVE., DENVER, CO 80216 (NAICS 337127). OSHA activity number 331112193.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- TOP SHOP INC.
- Site address
- 3220 E. 52ND AVE.
- City
- DENVER
- State
- CO
- ZIP
- 80216
- Mailing
- 5740 LOGAN ST., DENVER, CO 80216
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 337127
- Employees
- 35
- Ownership type
- A
Citations
3 citations on file for this inspection.
1910.213 C02
- Issued
- Jan 17, 2012
- Abate by
- Jan 24, 2012
- Penalty
- Initial $2,380 · Current $1,666 Reduced
General-duty citation text
29 CFR 1910.213(c)(2): Handfed circular ripsaw(s) were not furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator: (a) Top Shop Inc. dba American Cabinet and Flooring Inc. at 3220 E. 52nd Ave., Denver, CO 80216: The Delta table saw in the laminate shop was not equipped with a spreader. This condition exposed an employee to a kickback hazard. Abatement Note: To properly guard the saw: (a)The spreader shall: (1)The spreader shall be made of hard tempered steel, or its equivalent, and shall be thinner than the saw kerf. (2)The spreader shall be of sufficient width to provide adequate stiffness or rigidity to resist any reasonable side thrust or blow tending to bend or throw it out of position. (3)The spreader shall be attached so that it will remain in true alignment with the saw even when either the saw or table is tilted.
Recent events (2)
- — I (O) $1666
- — Z (S) $2380
1910.213 C03
- Issued
- Jan 17, 2012
- Abate by
- Jan 24, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.213(c)(3): Handfed ripsaw(s) did not have nonkickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator: (a)Top Shop Inc. dba American Cabinet and Flooring Inc. at 3220 E. 52nd Ave., Denver, CO 80216: The Delta table saw in the laminate shop was not equipped with nonkickback fingers or dogs. This condition exposed the employees to a kickback hazard. Abatement Note: To properly guard the saw the nonkickback fingers or dogs shall be located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator. They shall be designed to provide adequate holding power for all the thicknesses of materials being cut.
Recent events (2)
- — I (O) $0
- — Z (S) $0
1910.305 G01 IV A
- Issued
- Jan 17, 2012
- Abate by
- Jan 24, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(g)(1)(iii)[A]: Flexible cords and cables were used as a substitute for the fixed wiring of a structure: (a)Top Shop Inc. dba American Cabinet and Flooring Inc. at 3220 E. 52nd Ave., Denver, CO 80216: A flexible cable was used as a substitute for fixed wiring for a fan and radio near the Edgetech CTS740. This condition exposed the employee to electrical shock.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at TOP Shop INC.
View TOP Shop INC.'s full OSHA safety record →
More inspections in this industry (NAICS 337127)
More inspections in CO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 331112193.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.