FLAGLER, CO —
OSHA Inspection: FLAGLER COOPERATIVE ASSOCIATION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of FLAGLER COOPERATIVE ASSOCIATION in 221 E 2ND ST, FLAGLER, CO 80815 (NAICS 424510). OSHA activity number 334297710.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FLAGLER COOPERATIVE ASSOCIATION
- Site address
- 221 E 2ND ST
- City
- FLAGLER
- State
- CO
- ZIP
- 80815
- Mailing
- 221 E 2ND ST, FLAGLER, CO 80815
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 424510
- Employees
- 11
- Ownership type
- A
Citations
6 citations on file for this inspection.
1910.23 A08
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $1,785 · Current $1,200 Reduced
General-duty citation text
29 CFR 1910.23(a)(8): Every floor hole into which persons can accidentally walk were not guarded: a) On or about May 15, and at times prior, employees were exposed to tripping hazards where the opening of an out of service chute opening did not have a cover. The opening was located near the upper level of the manlift. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $1200
- — Z (S) $1785
1910.23 C01
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $1,785 · Current $1,200 Reduced
General-duty citation text
29 CFR 1910.23(c)(1): Open-sided floor(s) or platform(s) 4 feet or more above the adjacent floor or ground level were not guarded by standard railings (or the equivalent as specified in 29 CFR 1910.23(e)(3)(i) through (v)), on all open sides: On or about May 15, 2012, and at times prior, employees were exposed to fall hazards where below the feed mill, standard guardrails were not in place around the pit. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $1200
- — Z (S) $1785
1910.24 H
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $1,785 · Current $1,200 Reduced
General-duty citation text
29 CFR 1910.24(h): Standard railings were not provided on the open sides of all exposed stairways and stair platforms: a) On or about May 15, 2012, and at times prior, employees were exposed to fall hazards where in the tunnel, the stairway to the lower annex did not have a midrail. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $1200
- — Z (S) $1785
1910.219 E01 I
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $1,785 · Current $1,000 Reduced
General-duty citation text
29 CFR 1910.219(e)(1)(i): Horizontal belts which had both runs 42 inches or less from the floor level were not fully enclosed by guards conforming to requirements specified in 29 CFR 1910.219(m) and (o): a) On or about May 15, 2012, and at times prior, employees were not protected from nip point hazards where below the feed mill, the belt for the conveyor motor was not completely enclosed by the guard. Abatement Note: Abatement certication is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $1000
- — Z (S) $1785
1910.219 F03
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $2,380 · Current $0 Reduced
General-duty citation text
29 CFR 1910.219(f)(3): Sprocket wheels and chains which were seven -7 feet or less above floors or platforms were not enclosed: a) On or about May 15, 2012, and at times prior, employees were exposed to nip point hazards where chains and sprockets on the tripper were not guarded. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (S) $0
- — Z (S) $2380
1910.272 J01
- Issued
- May 23, 2012
- Abate by
- Jul 6, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.272(j)(1): The employer did not develop and implement a written housekeeping program that established the frequency and the method(s) determined best to reduce accumulations of fugitive grain dust on ledges, floors, equipment, and other exposed surfaces: a) On or about May 15, 2012, and at times prior, the housekeeping program for the feed mill was not adequately implemented. Dust accumulations in the basement were apparently in excess of 1/8 inch. Abatement Note: Abatement certification is required for this item (see enclosed "Certification of Corrective Action Worksheet").
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at Flagler Cooperative Association
View Flagler Cooperative Association's full OSHA safety record →
More inspections in this industry (NAICS 424510)
More inspections in CO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334297710.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.