OSHA Inspection: R&D REMODELING SERVICES, LLC

Issued

Jun 26, 2023

Penalty

Initial $5,357 · Current $5,357

General-duty citation text

29 CFR  1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.   a) Residential Construction located at 6625 Bench wood Path, Cumming , GA 30028. Roof: On or about 05/23/2023, and at times prior, the employer exposed employees to fall hazards at approximately 10-feet, 4 inches to the lower ground level, in that a fall protection system was not provided to employees engaged in framing activities.  R&D Remodeling Service's LLC was previously cited for a violation of this occupation safety and health standard or its equivalent standard 29 CFR 1926.501(b)(13), which was contained in OSHA Inspection Number 1498999, citation number 1, item number 2 and was affirmed as a final order date on 12/16/2020, with respect to a workplace located at (Lot #59) 386 Concord Street Alpharetta, GA 30009.

Issued

Jun 26, 2023

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR  1926.403(b)(1):Examination. The employer shall ensure that electrical equipment is free from recognized hazards that are likely to cause death or serious physical harm to employees. Safety of equipment shall be determined on the basis of the following considerations:  a) Residential construction located at 6625 Bench wood Path, Cumming , GA 30028. On or about 05/23/2023, and at times prior, the employer failed to inspect all electrical extension cords used to provide power to electric tools employees were using, in that a orange 100-ft. electrical cord was damaged and exposing the internal insulated energized wires. An inspection of these cords was not performed prior to the shift as these cords were not repaired or removed from service.