Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: XIANG WANG CONSTRUCTION CORPORATION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of XIANG WANG CONSTRUCTION CORPORATION in LOT 7067 G-2-9-R2, YIGO, GU 96929 (NAICS 236115). OSHA activity number 339479115.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Xiang Wang Construction Corporation — free Get an email when a new federal OSHA severe-injury report for Xiang Wang Construction Corporation is published. One employer, no account, unsubscribe in one click.
Site address
LOT 7067 G-2-9-R2
City
YIGO
State
GU
ZIP
96929
Mailing
P.O. BOX 315752, TAMUNING, GU 96931
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
236115
Employees
10
Ownership type
A

4 citations on file for this inspection.

1926.50 C

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Dec 26, 2013
Abate by
Jan 23, 2014
Penalty
Initial $1,440 · Current $0 Reduced
29 CFR 1926.50(c): A person who has a valid certificate in first-aid training was not available at the worksite to render first-aid:  At the side of the carport on November 12, 2013, and times prior thereto, there was no person on-site who had a valid certificate in first-aid training from the U.S. Bureau of Mines, the American Red Cross, or equivalent training. Documentary evidence of certification was not be available at the worksite.  NOTE: Distance from the worksite to the Guam Memorial Hospital is approximately 9.7 miles. Estimated time is about 19 minutes.
Recent events (2)
  • — I (S) $0
  • — Z (S) $1440

1926.501 B10

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Dec 26, 2013
Abate by
Jan 23, 2014
Penalty
Initial $1,800 · Current $0 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest.  At the roof of the project site on November 12, 2013, two employees tying rebar were not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Employees were exposed to a fall hazard of about 9 feet, 4 inches to the ground.
Recent events (2)
  • — I (S) $0
  • — Z (S) $1800

1926.1053 B01

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Dec 26, 2013
Abate by
Jan 23, 2014
Penalty
Initial $2,200 · Current $0 Reduced
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladders length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  At the side of the carport on November 12, 2013, a ten foot fiberglass stepladder used to access the roof did not extend at least 3 feet  above the upper landing surface. The top of the ledge was about 12 feet above the ground.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2200

1926.1053 B04

Deleted Serious Gravity 5 1 instance 4 exposed
Issued
Dec 26, 2013
Abate by
Jan 23, 2014
Penalty
Initial $0 · Current $0
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed:  At the side of the carport on November 12, 2013, employees used a ten foot fiberglass stepladder with the metal spreader or locking device in the partially closed position to access the roof.  The metal spreader or locking device is designed to hold the front and back sections of the stepladder when the ladder is being used.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View Xiang Wang Construction Corporation's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339479115.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.