COLUMBUS, OH —
OSHA Inspection: SENECA STEEL ERECTORS INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of SENECA STEEL ERECTORS INC. in 3075 LOYALTY CIRCLE BUILDING 3, COLUMBUS, OH 43219 (NAICS 238120). OSHA activity number 341621357.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SENECA STEEL ERECTORS INC.
- Site address
- 3075 LOYALTY CIRCLE BUILDING 3
- City
- COLUMBUS
- State
- OH
- ZIP
- 43219
- Mailing
- 2727 TULLER PARKWAY SUITE 280, DUBLIN, OH 43017
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238120
- Employees
- 62
- Ownership type
- A
Citations
11 citations on file for this inspection.
1926.350 A09
- Issued
- Oct 18, 2016
- Penalty
- Initial $3,741 · Current $0 Reduced
General-duty citation text
29 CFR 1926.350(a)(9): Compressed gas cylinders shall be secured in an upright position at all times except, if necessary, for short periods of time while cylinders are actually being hoisted or carried. a. In the storage container where acetylene and oxygen cylinders were stored, the employer did not secure the cylinders from being knocked over and striking employees thereby exposing employees to a struck-by hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $3741
1926.453 B02 V
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $17,459 · Current $0 Reduced
General-duty citation text
29 CFR 1926.453(b)(2)(v): A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift. a. On the steel erection site where employees were installing bridging, bracing and welding steel and accessed the steel from a sixty foot JLG Aerial Lift, the employees were observed going up and down in the lift not connected to an attachment point in the JLG thereby exposing employees to a fall hazard. Seneca Steel Erectors Inc. was previously cited for a violation of this occupational safety and health standard 29 CFR 1926.453(b)(2)(v), which was contained in OSHA inspection number 890423, citation number 1, item number 2 and was affirmed as a final order on 2-27-2013, with respect to a workplace located at 5825 Venture Drive, Dublin, Ohio 43017.
Recent events (2)
- — I (S) $0
- — Z (R) $17459
1926.350 A10
- Issued
- Oct 18, 2016
- Penalty
- Initial $3,741 · Current $3,741
General-duty citation text
29 CFR 1926.350(a)(10): Oxygen cylinders in storage shall be separated from fuel-gas cylinders or combustible materials (especially oil or grease), a minimum distance of 20 feet (6.1 m) or by a noncombustible barrier at least 5 feet (1.5 m) high having a fire-resistance rating of at least one-half hour. a. In the storage container where gas cylinders were stored, the employer stored an acetylene cylinder within 3 feet of a oxygen cylinder thereby exposing employees to a fire hazard.
Recent events (2)
- — I (S) $3741
- — Z (S) $3741
1926.453 B02 VI
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $8,730 · Current $8,730
General-duty citation text
29 CFR 1926.453(b)(2)(vi): Boom and basket load limits specified by the manufacturer shall not be exceeded. a. On the site four employees were in the basket of a JLG 600S aerial lift used to access upper working levels of a multi story steel building and also to be lowered back to ground level. The employees and their tools together exceeded the rated capacity of the lift and were thereby exposed to the hazards associated with failure of the lift.
Recent events (2)
- — I (S) $8730
- — Z (S) $8730
1926.454 B
- Issued
- Oct 18, 2016
- Abate by
- Nov 21, 2016
- Penalty
- Initial $8,730 · Current $0 Reduced
General-duty citation text
29 CFR 1926.454(b): The employer shall have each employee who is involved in erecting, disassembling, moving, operating, repairing, maintaining, or inspecting a scaffold trained by a competent person to recognize any hazards associated with the work in question. The training shall include the following topics, as applicable: a. On the site where employees worked out of a JLG 600S Aerial Lift, the employer did not provide training in the safe use of operating the aerial lift thereby exposing employees to a fall and crushing hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $8730
1926.753 E01
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $6,236 · Current $0 Reduced
General-duty citation text
29 CFR 1926.753(e)(1): A multiple lift shall only be performed if the following criteria are met: 29 CFR 1926.753(e)(1)(i): A multiple lift rigging assembly is used; a. On the site where the steel erector was performing multiple steel lifts, (Christmas Treeing) the employer did not use a multiple lifting device while raising and connecting three pieces of steel thereby exposing employees to a struck-by hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $6236
1926.760 A01
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $8,730 · Current $8,730
General-duty citation text
29 CFR 1926.760(a)(1): Except as provided by paragraph (a)(3) of this section, each employee engaged in a steel erection activity who is on a walking/working surface with an unprotected side or edge more than 15 feet (4.6 m) above a lower level shall be protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems or fall restraint systems. a. On the site where employees were welding or attaching steel braces, employees were not connected to a fall protection device when walking the steel on the exterior wall thereby exposing employees to a 59 foot fall hazard.
Recent events (2)
- — I (S) $8730
- — Z (S) $8730
1926.761 B
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $8,730 · Current $0 Reduced
General-duty citation text
29 CFR 1926.761(b): Fall hazard training. The employer shall train each employee exposed to a fall hazard in accordance with the requirements of this section. The employer shall institute a training program and ensure employee participation in the program. a. On the site where employees were connecting, attaching bridging and attaching bracing, the employer did not provide a training program to inform employees of the hazards associated with working at heights up to 59 feet thereby exposing employees to a fall hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $8730
1926.761 C01
- Issued
- Oct 18, 2016
- Abate by
- Nov 21, 2016
- Penalty
- Initial $8,730 · Current $0 Reduced
General-duty citation text
29 CFR 1926.761(c)(1): Multiple lift rigging procedure. The employer shall ensure that each employee who performs multiple lift rigging has been provided training in the following areas: a. On the site where the Alliance Data Building No. 3 was being built, the employee performing the multiple lift (Christmas Treeing) was not provided training prior to being required to lift multiple pieces of steel thereby exposing employees to a struck-by hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $8730
1926.1425 C03
- Issued
- Oct 18, 2016
- Abate by
- Nov 21, 2016
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1425(c)(3): The materials must be rigged by a qualified rigger. a. On the site the steel erector did not provide a qualified rigger to rig sections of steel being hoisted to the top of the structure for connecting around the elevator shaft thereby exposing employees to a struck-by hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.453 B02 IV
- Issued
- Oct 18, 2016
- Abate by
- Oct 28, 2016
- Penalty
- Initial $17,459 · Current $17,459
General-duty citation text
29 CFR 1926.453(b)(2)(iv): Employees shall always stand firmly on the floor of the basket, and shall not sit or climb on the edge of the basket or use planks, ladders, or other devices for a work position. a. On the site, employees utilized a JLG 600S aerial lift to access upper levels of a multi story steel building. The employees climbed over the top rail of the basket to access the structure and were exposed to a fall of 59 feet to the ground. The Seneca Steel Erectors Inc. was previously cited for a violation of this occupational safety and health standard 29 CFR 1926.453(b)(2)(iv), which was contained in OSHA inspection number 890423, citation number 1, item number 1 and was affirmed as a final order on 2-27-2013, with respect to a workplace located at 5825 Venture Dr. Dublin, Ohio 43017.
Recent events (2)
- — I (R) $17459
- — Z (R) $17459
More inspections at Seneca Steel Erectors INC.
View Seneca Steel Erectors INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238120)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341621357.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.