ABINGTON, MA —
OSHA Inspection: JMT CARPENTRY & SIDING, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JMT CARPENTRY & SIDING, INC. in 135 PLYMOUTH STREET, ABINGTON, MA 02351 (NAICS 238160). OSHA activity number 343177150.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JMT CARPENTRY & SIDING, INC.
- Site address
- 135 PLYMOUTH STREET
- City
- ABINGTON
- State
- MA
- ZIP
- 02351
- Mailing
- 28 CHURCH STREET, MILFORD, MA 01757
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 5
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.416 A01
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $3,880 · Current $2,716 Reduced
General-duty citation text
29 CFR 1926.416(a)(1): Employees were permitted to work in proximity to electric power circuits and were not protected against electric shock by de-energizing and grounding the circuits or effectively guarding the circuits by insulation or other means: Front Middle of Roof: Employees were performing roofing work in close proximity to the power service line for the home which had not been de-energized or insulated, exposing employees to electric shock hazards.
Recent events (2)
- — I (S) $2716
- — Z (S) $3880
1926.501 B13
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $3,880 · Current $2,716 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): Jobsite: Employees were stripping old roof shingles and preparing to install new roof shingles near the edge of the roof without fall protection exposing them to falls of approximately nine (9) feet to the ground and concrete below.
Recent events (2)
- — I (S) $2716
- — Z (S) $3880
1926.1053 B01
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $3,880 · Current $2,716 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: Near the garage: An aluminum extension ladder that was being used to access the roof did not extend three (3) feet above the upper landing exposing employees to falls.
Recent events (2)
- — I (S) $2716
- — Z (S) $3880
1926.1053 B09
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(9): The area around the top and/or bottom of (a) ladder(s) was not kept clear: Near the garage: An aluminum extension ladder that was being used to access the roof was not free of construction debris at the bottom, exposing employees to falls.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B16
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(16): Portable ladders with structural defects, such as, but not limited to, broken or missing rungs, cleats, or steps, broken or split rails, corroded components, or other faulty or defective components, were not either immediately marked in a manner that readily identifies them as defective, or tagged with "Do Not Use" or similar language, and were not withdrawn from service until repaired. Near the garage: An aluminum extension ladder that was being used to access the roof was damaged, exposing employees to falls.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B20
- Issued
- May 31, 2018
- Abate by
- Jul 20, 2018
- Penalty
- Initial $3,880 · Current $2,716 Reduced
General-duty citation text
29 CFR 1926.1053(b)(20): Employees did not face the ladder when ascending or descending the ladder: Near the garage: An employee descended from the roof facing away from the aluminum extension ladder, exposing the employee to a fall hazard.
Recent events (2)
- — I (S) $2716
- — Z (S) $3880
More inspections at JMT Carpentry & Siding, INC.
View JMT Carpentry & Siding, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238160)
More inspections in MA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343177150.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.